The realization of compensation for the trick recognition of the computerized quilting embroidery machine means that when the computerized quilting embroidery machine is quilting a trick, the tricks are collected on time and the trick parameters are recognized, and online proofreading is performed according to the recognized trick parameters. Because of the deformation of the fabric, the starting point of the trick is cheap, so there needs to be a trade-off on the results of online proofreading.

First, try to keep the shape of the trick unchanged;

Second, try to keep the direction of the trick unchanged. Try to maintain the same position as possible, because the quilting point will be cheap, and the quilting trick will be deformed; if you want to keep the shape of the trick unchanged, then proofread based on the offset of the quilting point, which is a quilting trick. The bearing is shifted. According to the introduction of the definition of computerized quilting embroidery machine, computerized multi-needle quilting embroidery machine refers to a computerized quilting machine that can use multiple needles together to sew fabrics with continuous and regular stitches. It is mostly used in the manufacture of clothing, bedding and decoration fabrics, especially in the quilting embroidered and embroidered various high-end mattresses, beddings, home decorations, etc. It is a kind of common mattress mechanical equipment, which has faster quilting speed, flat and beautiful stitches, and also has the characteristics of high-end functions such as disconnection and parking.



Pay attention to the following points when replacing parts of the computerized quilting embroidery machine:

1 Repair and replacement parts should be operated by experts as much as possible, and do not disassemble by mistake if you don’t understand

2 The repaired or replaced parts must be supplied or approved by the original manufacturer, and the types are relative, before they can be replaced for testing.

3 When replacing the parts of the computerized quilting embroidery machine, if it is necessary to open the electric control box, be sure to cut off the power and wait for five minutes before operating. Do not wet your hands.

4 Use professional tools and strictly follow the instructions to enter the quilting machine component replacement. The machine should be placed in a stable position during the replacement operation.

5 After the replacement job is completed, check again. Acknowledge whether the solder should touch other quilting machine parts, the insulating material on the circuit board should be restored to its original state; whether the touch of the wire terminals and plugs is outstanding, the screws and nuts should not fall without operation, and should be tightened without looseness .

6 After the replacement of the parts of the computerized quilting embroidery machine is completed, it must be tested and then put into normal work. During the test run, pay attention to the hair and clothing not to touch the pulley and belt, and take safety measures.